No luck on my first attempt. If anyone can spot a misstep pls point out:
I'm using Waveshare SH1106: https://www.waveshare.com/1.3inch-oled-b.htm Wiring: 1 VCC Power positive (3.3~5V power input) [GPIO 3.3V] 2 GND Ground [GPIO GND] 3 NC NC 4 DIN Data input [GPIO 10 (MOSI)] 5 CLK Clock signal input [GPIO 11 (SCLK)] 6 CS Chip selection, low active [GPIO (CE0)] 7 D/C Command signal, low level for command, high level for data [GPIO 24] 8 RES Reset signal, low active [GPIO 25] Each lmsmonitor I run with -o7. I tried i2cdetect, but nothing shows up. Not needed because I'm using 4-wire SPI? ls /dev/spi shows correctly as does lsmod spi. lmsmonitor runs and refreshes, but no display. Maybe the wiring if off? ------------------------------------------------------------------------ LiFePO4's Profile: http://forums.slimdevices.com/member.php?userid=71240 View this thread: http://forums.slimdevices.com/showthread.php?t=111790 _______________________________________________ unix mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/unix
