shunte88 wrote: > I picked up the case on fleaBay for cheap, shipped from China so a few > weeks in transit these days > > I then used Frontpanel Express for the CNC work - front and rear panels > > Audiophonics and DIYAudio have similar cases, very bare bones and you > don't need to spend a ton - I'm betting t'zon, Alibaba, etc have good > choices too > > That was 6-7 years ago and FPEx work was [good but] pricey, especially > when you futz the OLED measurements and have to repeat the order, the > OLED is recessed into the panel with extra space for the kapton flex > PCB > > The combined cost of that work would purchase a 3018 CNC at today's > prices. > > I've since purchased a couple of CNC machines so I'm setup to do the > work myself. > > I've seen folks using acrylic and even PCB's for the panels, > PCBWay/China etc, with the benefit of printed surfaces, standoffs etc in > a number of colors. You can get the work done for pennies leveraging > Shenzen resources > > I've surfaced the LMS Server overrides so no need for the PR > > I'll get this update out ASAP
Excellent thanks! I am looking for to the updates. I've been playing around with FPEx, then I clicked on order panels :D. -MrD =================== 3 PiCore Players 1 Transporter (dead) 2 Squeezebox v3 (1 dead, 1 resurrected) Linux x86-64 SlimServer 8.1.1 ------------------------------------------------------------------------ MrD's Profile: http://forums.slimdevices.com/member.php?userid=6099 View this thread: http://forums.slimdevices.com/showthread.php?t=111790 _______________________________________________ unix mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/unix
