Hi,

I saw a thread from September 2014 entitled
   "Digilent Nexys-4 xilinx board FT2232".
Question was whether urjtag can be used to program the new
Digilent boards with a FTDI 2232 JTAG/UART interface.

I couldn't see a success story, but a message posted by
Steve Tell with a clear description of the board logic
(which is always hidden in the Digilent schematics).

Almost 3 years later, also after svf support was added to
vivado, here again the question:

   Did somebody succeed to program a Nexys4, Basys3 or alike
   with urjtag, and if yes, with which settings ?


                        With best regards,      Walter


------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
UrJTAG-development mailing list
UrJTAG-development@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/urjtag-development

Reply via email to