On Fri, Feb 23, 2018 at 1:08 AM, S. Franks <bahamasfra...@gmail.com> wrote: > I have embedded an FT232H chip on my latest Max10 (altera/intel) fpga pcb. > As you can see, it is recognized by my linux host: > [12565.769519] usb 3-1.4.1: new high-speed USB device number 6 using xhci_hcd > [12565.872136] usb 3-1.4.1: New USB device found, idVendor=0403, > idProduct=6014 > [12565.872144] usb 3-1.4.1: New USB device strings: Mfr=1, Product=2, > > However, when I try to use UrJtag, I get the following errors: > > jtag> cable ARM-USB-OCD-H vid=0403 pid=6014 > error: Couldn't connect to suitable USB device. > error: ftdi/ftd2xx error: ftdi_usb_open_desc() failed: device not found
Have you tried 0x0403 and 0x6014 ? Those are hex numbers.. Do you have access to write to USB device? Have you tried running as root? > Just for reference, pins are connected as such: ADBUS0=TCK, > ADBUS1=TDI, ADBUS2=TDO, ADBUS3=TMS, ADBUS7=RTCK. This is the best I > could find online as far as hooking up to the jtag pins. All ACBUS > pins are no connect. Those pin configurations are part of ftdi driver for a given cable. If you dont find a cable with this exact pinout, there is a chance you will have to add it yourself as new cable variant.. Best regards :-) Tomek -- CeDeROM, SQ7MHZ, http://www.tomek.cedro.info ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ UrJTAG-development mailing list UrJTAG-development@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/urjtag-development