Yes i believe it works so too as Mark says.
@BR make sure that for your next release, that when now your highest
versioncode is 15 for x86-64
the armv7a starts with 16
that's why i showed you the sequence as example.
you need to increase the versioncodes but with the lowest versioncode
for the lowest architecture, i did it too and had no problem
so like this for your sequence if your highest used VC is 15 then:
Build VC
arm v7a 16 ---->next time --->20---->next time--->24
arm64 17---->next time--->21--->next time--->25
X86 18--->next time--->22--->next time--->26
x86-64 19--->next time--->23--->next time--->27
and so on, you see the 64 builds need to be higher vc then the 32bits
Op 14-6-2019 om 10:33 schreef Mark Waddingham via use-livecode:
On 2019-06-14 00:41, Sannyasin Brahmanathaswami via use-livecode wrote:
Aloha Jerry, I think I have done it correctly
1)
I have the four builds in one release
2)
Native platforms -- armeabi-v7a - version code 14
Native platforms -- x86_64 - version code 9
Native platforms -- x86 - version code 8
Native platforms -- arm64-v8a - version code 7
I still get ERROR
=============
1 message for APK 7
Fully shadowed APK
Problem:
This APK will not be served to any users because it is completely
I wonder if the reason this didn't work is because you have the
version code
for armv7 > that for arm64...
I suspect the play store will choose the highest version coded APK
that will
run on the target device. As ARMv7 APKs will run on devices which can
run ARM64,
it will choose the ARMv7 in preference (as it is version code 14,
which is greater
than 7) and thus 'completely shadow' the ARM64 APK.
Upshot: probably best to make sure ARM64 APKs have higher version code
than
ARM7 ones (the same is true of x86-64 and x86 - but in that case
you've already
got version-code-of(x86-64) > version-code-of(x86) which is why you
aren't getting
a shadowed error for those)
Warmest Regards,
Mark.
_______________________________________________
use-livecode mailing list
use-livecode@lists.runrev.com
Please visit this url to subscribe, unsubscribe and manage your subscription
preferences:
http://lists.runrev.com/mailman/listinfo/use-livecode