Monte (and Paul),
Thanks for reporting your findings. I have been struggling with this issue for
some time (with LC 7.0.1). Adding the default folder to the path to the DLL
fixed the problem.
However, now that it's PDFing, a new problem exists. If I "open printing to
pdf" and then run multiple "print card" commands, each print comes out as a
separate document and I am asked to select a location to save the output for
each page. I haven't issues a "close printing" command yet, but it's still
outputting separate PDFs. It works fine in the IDE, it works fine in the Mac
Standalone, but I get this odd behavior on with the Windows standalone.
One note... I "open printing to pdf" in stack A. Then, I open stack B and do
the "print card" commands. Then, I close stack B and stack A issues the "close
printing" command. I then repeat as needed. I don't think this matters as it
works in the IDE and on the Mac.
Any thoughts?
Thank you in advance!
-Dan
> On 27 Jul 2016, at 4:43 PM, Paul Dupuis <p...@researchware.com> wrote:
>
> Monte,
>
> Thank you so much - exactly that - so for LC6.x I added the follow which
> address the problem whether in the IDE or standalone
>
> put the defaultFolder into tSaveDefaultFolder
> if (the environment is "development") then -- IDE
> set the defaultFolder to specialFolderPath("engine")
> else -- standalone
> set the defaultFolder to appPath()
> end if
>
> -- do my PDF printing
>
> set the defaultFolder to tSaveDefaultFolder
>
> If I every see you at a LiveCode Conference (I have to attend Edinburgh
> via webcast this year), I owe you drinks or a meal or both!
_______________________________________________
use-livecode mailing list
use-livecode@lists.runrev.com
Please visit this url to subscribe, unsubscribe and manage your subscription
preferences:
http://lists.runrev.com/mailman/listinfo/use-livecode
