Ok from my other post I think I figured out what is going on but I do not understand why. Well I do a little bit.
When I was createing the new stack the first card was the last card. Since I had to go to the stack at some point rev remebered the last/first card ie the current card. So every time I was sendind the create card command it was all ways at the end. When I restarted the standalone Rev set the current card back to the first card of that stack,even though I said of last card. The work around was at startup to go to the last card of that stack. I do not like this because now the screen flashes because of the way the lock screen works. Can I set witch card is the current card with out going to the stack. > Mac 8.1 Rev 1.1 > > Background: I am using a rev stack like a db. Posting info to it. The problem > below happens in the Developement & Standalone. > > on startup > set the stackfiles of this stack to "stack2,stack2.rev" > end startup > > on handler > > set defaultstack to "stack2" > send "create card" to last card of stack "stack2" > Put info into field 1 of last card > set defaultstack to "stack1" > end handler > > Rev keeps creating the new card after the first one. But puts the info into > the last card. Same Problem even if I remove "of stack "stack2"" of line 2 of > handler > > But If I do this: > > During the same time that the standalone is open and I create the stack Stack2 > then run the above handler it works fine. If I close the standalone then re > open the standalone with out createing the stack, because the stack is already > there, then the above handler does not work. > > I am unsure why one works and the other does not. > > Thank you _______________________________________________ use-revolution mailing list [EMAIL PROTECTED] http://lists.runrev.com/mailman/listinfo/use-revolution
