My situation was that each clone was a number letter combo ie "13i" and "13ii" etc.
It so happened that the clone it stopped on was one without any letters in it. ie. "17" no "i" etc.
Also, the stack became corrupted/sick and I could not delete the trouble clone. I had to go back to a saved version and try again.
I added a letter to it and was able to clone that one and get past that number. All others cloned OK.
I assumed that was what it was anyway but it may have been a certain number of clones that it crashed on. Since I just proceeded after that clone and not from the beginning I don't know if a certain number of clones may have been at fault.
Tom
On Jan 24, 2004, at 3:22 PM, David Squance wrote:
I have a script which stops on one step which involves cloning a card.
There's no error message. The same script works fine to a certain point,
cloning other cards, but when it reaches a certain one, won't go any
further. The standalone (OS X, same as development) works fine. I tried
running it in the IDE with suppressing (or is it suspending) the
development environment, but I had to force quit Rev. Any suggestions?
_______________________________________________ use-revolution mailing list [EMAIL PROTECTED] http://lists.runrev.com/mailman/listinfo/use-revolution
Thomas J. McGrath III SCS 1000 Killarney Dr. Pittsburgh, PA 15234 412-885-8541
_______________________________________________ use-revolution mailing list [EMAIL PROTECTED] http://lists.runrev.com/mailman/listinfo/use-revolution
