Here is the link again if you or anyone else is interested. I think this is an underlying problem that should be affecting more people.
<http://www.canelasoftware.com/pub/rev/clone_test.mc.zip>
-Mark Talluto
On Mar 1, 2004, at 6:36 AM, Thomas McGrath III wrote:
After a clone the Application Browser does not always update right away. Close the AB and then reopen it while still in the IDE and it should now say 2.
HTH
Tom
On Mar 1, 2004, at 1:11 AM, Mark Talluto wrote:
Hi Everyone,
This is going to be sorta vague right now. I am running into a situation where I am getting a particular result from my app running in the IDE vs a Standalone.
I am cloning a card.
In the IDE the visible card after the clone is card 1 of 2.
In the Standalone the visible card after the clone is card 2 of 2 (which is the way it should be I believe).
A lot is going on so a simple recipe stack has been impossible to create as of yet. This might (probably is) be related. When I have "Script Debug Mode" on, the stack does not execute completely. It is hanging on the "clone this card" line.
I tested this on MC 2.5 and it ran in both the IDE and Standalone with the same results.
Has anyone here had something like this happen to them? I will bugzilla this once I can create a recipe without having to send in my whole app.
-- Best regards, Mark Talluto http://www.canelasoftware.com _______________________________________________ use-revolution mailing list [EMAIL PROTECTED] http://lists.runrev.com/mailman/listinfo/use-revolution
Thomas J. McGrath III SCS 1000 Killarney Dr. Pittsburgh, PA 15234 412-885-8541
_______________________________________________ use-revolution mailing list [EMAIL PROTECTED] http://lists.runrev.com/mailman/listinfo/use-revolution
_______________________________________________ use-revolution mailing list [EMAIL PROTECTED] http://lists.runrev.com/mailman/listinfo/use-revolution
