On Jun 16, 2004, at 7:43 PM, [EMAIL PROTECTED] wrote:
I use a Lantronix uds100 serial server. I can configure the baudrate, the
stop bit, the parity etc., but cannot set rts high and dtr low, because it
is some low-level programming.. I am searching for other serial
devices...
The Lantronix UDS100 has a DCE connector. The outputs are DCD, DSR and CTS. Your other cable will not work.
Try putting a little gadget with LED indicators on the output of the UDS100. Fiddle with the flow control until you get at least one of the output control lines always high and one always low when the port is open. If that can't be done, try to find away to make the weather station work without it or get another device. If you can get a high and a low control line, then wire that up so it works.
The Lantronix UDS100 can be powered either from the DCE connector on special lines or via a separate power connection.
Dar Scott
_______________________________________________ use-revolution mailing list [EMAIL PROTECTED] http://lists.runrev.com/mailman/listinfo/use-revolution
