Basically here's what's going on... the next version of Rev will not run properly with explicitVariables turned on (just like it does now). HOWEVER, there is a special "Variable Checking" mode that you can put the Script Editor in so that it will check your scripts as if it had explicitvars on (so you can catch all your scripting boo-boos), but does not put the entire Rev IDE under explicitVariables.
So basically, turning on explicitVariables yourself will cause the IDE (both this and the next versions) to have problems. RunRev has promised to get the IDE "explicitVars-clean", but it may take another version before that has been done. Anyway, that's MY understanding of the situation... Ken Ray Sons of Thunder Software Email: [EMAIL PROTECTED] Web Site: http://www.sonsothunder.com/ > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of > Alex Tweedly > Sent: Wednesday, July 14, 2004 1:09 PM > To: How to use Revolution > Subject: RE: Setting explicitVariables > > > At 12:48 14/07/2004 -0500, Ken Ray wrote: > > >Actually, Alex, Mark should have said "upcoming version" of > the script > >editor. 'Variable Checking' is in the Script menu of the > Script Editor > >in the next version of Rev (currently-in-alpha). > > Cool ! Best answer I could have hoped for. > > (Actually, any answer that didn't start "You just missed it > you dummy, it's > at ..." would have been good :-) > > So - is there any way to set it today, other than the > (apparently unsupported) "set explicitVariables to true" > method I used before ? Or is that method expected to be OK in > 2.2, and only becomes inadvisable in > next release ? > > -- Alex. > _______________________________________________ use-revolution mailing list [EMAIL PROTECTED] http://lists.runrev.com/mailman/listinfo/use-revolution
