Nicolas Cueto nrkweto03 at hotmail.com wrote (Sun Jan 2, 2005):
Wihelm Sanke wrote:
> Try removing the script of btn "revtable" of stack "revlibrary" from front.-
Hmmm... not 105% sure how to put this advise into effect. However, I tried
what I think was meant (see below), and still the long delay when using the
pointer tool to move an object on the card I mentioned.
Thanks all the same.
Cheers, Nicolas Cueto
I had suggested this because in the case of one of my stacks with quite a number of controls (Bugzilla 2019) this helped.
What about the other frontscripts? There are three more used in the Rev IDE.
As I do not know exactly which features of your stack may be involved, it is difficult to give advice, but I would offer to take a look at your stack.
And, you could give it a try and run and work on your stack in the Metacard IDE, which does not use frontscripts and is less complex than the Rev IDE also in other respects. Of course, only if you do not need special features that are provided only by the Rev IDE.
Regards,
Wilhelm Sanke <www.sanke.org/MetaMedia>
_______________________________________________ use-revolution mailing list [email protected] http://lists.runrev.com/mailman/listinfo/use-revolution
