>How to start Rev engine without the IDE, so i can, from >my favorite Editor and Perl environment, read, write, update >scripts or customs properties in stacks... > >Still realistic ?
if you write a stack file parser, im sure many will be intersted... GOOD LUCK though! Otherwise, I wrote my own script editor based on RunRev and it's much better than their own... Normally, you want to just "control" the IDE to run batches which is what I thought you wanted... >>>is there a way to run Rev as a batch system, >>>a bit the same as a CGI script, but on windows ? >>> >>>thanks for any clue, ----------------------------------------- Visit us at http://www.clearstream.com IMPORTANT MESSAGE Internet communications are not secure and therefore Clearstream International does not accept legal responsibility for the contents of this message. The information contained in this e-mail is confidential and may be legally privileged. It is intended solely for the addressee. If you are not the intended recipient, any disclosure, copying, distribution or any action taken or omitted to be taken in reliance on it, is prohibited and may be unlawful. Any views expressed in this e-mail are those of the individual sender, except where the sender specifically states them to be the views of Clearstream International or of any of its affiliates or subsidiaries. END OF DISCLAIMER _______________________________________________ use-revolution mailing list [email protected] http://lists.runrev.com/mailman/listinfo/use-revolution
