Hi Bob, Just make the rect of the group larger before your resize. I tend to locklocation each group to make sure it is always correctly refreshed. Then you can resize/move the buttons without loosing sight of them...
cheers Xavier On 09.05.2005 14:56:59 use-revolution-bounces wrote: >Hi All. > >I have been experimenting with some simple grouping. If I have a stack of one >size and put 3 controls on it and group them, then the group is only as big as >the area of the controls. Now I have a problem, since my controls are >resizeable by the user, therefore, when the resize to bigger than the original >group area, the resized controls are not totally visible. Is there a way to >make the group area as big as the card? > >Cheers >Bob > > >_______________________________________________ >use-revolution mailing list >[email protected] >http://lists.runrev.com/mailman/listinfo/use-revolution ----------------------------------------- Visit us at http://www.clearstream.com IMPORTANT MESSAGE Internet communications are not secure and therefore Clearstream International does not accept legal responsibility for the contents of this message. The information contained in this e-mail is confidential and may be legally privileged. It is intended solely for the addressee. If you are not the intended recipient, any disclosure, copying, distribution or any action taken or omitted to be taken in reliance on it, is prohibited and may be unlawful. Any views expressed in this e-mail are those of the individual sender, except where the sender specifically states them to be the views of Clearstream International or of any of its affiliates or subsidiaries. END OF DISCLAIMER _______________________________________________ use-revolution mailing list [email protected] http://lists.runrev.com/mailman/listinfo/use-revolution
