If I enter the following handler with "ccw" or "cw", it works
perfectly. When I enter with "flip" or "mirror", the requested
operation is performed perfectly, but afterwards the cursor turns into a
plus sign, and I have to switch from run mode to design mode and back to
run mode before I can run the program again. I'm sure the change in
cursor is a clue as to what is going on, but I don't understand it. Any
hints?
Jon Bondy
on menuPick s
if s = "ccw" then
get angle of image "image"
add 90 to it
set angle of image "image" to it
end if
if s = "cw" then
subtract 90 from it
set angle of image "image" to it
end if
if s = "flip" then flip image "image" vertical
if s = "mirror" then flip image "image" horizontal
end menuPick
_______________________________________________
use-revolution mailing list
[email protected]
http://lists.runrev.com/mailman/listinfo/use-revolution
