Hi,
I insert the following code into the preOpenStack handler:
if (the environment = "development") and (the tool = "pointer
tool") then
exit preOpenStack
end if
This has the effect of stopping the message paths from executing IF
the stack is being run with the IDE in "Pointer" mode, that way you
can look at your Script and make changes. To actually run the script,
you close the stack, put the IDE into "Browse" mode and then relaunch
the stack.
Hope this helps
All the Best
Dave
On 26 Apr 2006, at 21:23, Garrett Hylltun wrote:
Björnke von Gierke wrote:
On Apr 26 2006, at 21:49, Garrett Hylltun wrote:
...
How do I get the Rev Studio IDE to not run the preOpenStack and
openStack when I first open the stack in the Rev IDE?
...
In the ide, there's the toolbar, and on that you can check/uncheck
the "messages" button. It does the same as "lock messages".
Thank you thank you thank you thank you thank you! :-)
I was completely freaking out over this as I have put weeks into
this and thought I was going to have to start all over again.
Thanks,
-Garrett
_______________________________________________
use-revolution mailing list
[email protected]
Please visit this url to subscribe, unsubscribe and manage your
subscription preferences:
http://lists.runrev.com/mailman/listinfo/use-revolution
_______________________________________________
use-revolution mailing list
[email protected]
Please visit this url to subscribe, unsubscribe and manage your subscription
preferences:
http://lists.runrev.com/mailman/listinfo/use-revolution
