On Friday 07 January 2005 00:56, Rolf Brusletto wrote: > Hey all, > > Its my first time using uml, so this question might be a simple yes, or > (hopefully) there is something I'm missing to pick up speed. I have a > system, which normally gets about 520Mb/s( w/ netpipe) max that under > uml will maybe get up to 61Mb/s, then immediately drop down to around > 9Mb/s. The latency is also quite a bit higher. Current mode for the uml > is tt, and mem is set at 128M, which for all intensive purposes > shouldn't be too bad, should it? I've read a little about skas, will > this help the issue much at all? SKAS is lots of times faster than TT. And is also more stable, because TT mode is less used and less debugged, in the common practice.
I've no idea about the other questions, answering only to the above one, sorry. Bye > Currently network is setup bridged with > eth0 and tap0 promisc, and ip on uml eth0. Any ideas? > > Thanks in advance, > > Rolf -- Paolo Giarrusso, aka Blaisorblade Linux registered user n. 292729 http://www.user-mode-linux.org/~blaisorblade ------------------------------------------------------- The SF.Net email is sponsored by: Beat the post-holiday blues Get a FREE limited edition SourceForge.net t-shirt from ThinkGeek. It's fun and FREE -- well, almost....http://www.thinkgeek.com/sfshirt _______________________________________________ User-mode-linux-user mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/user-mode-linux-user
