On Jan 12, 2008 5:14 PM, Jeff Dike <[EMAIL PROTECTED]> wrote:
> On Thu, Jan 10, 2008 at 12:47:12PM +0100, Magnus Legardt wrote:
> > The only way I get this to work is by using the following ugly
> workaround on
> > the host system before booting the virtual machines:
>
> How do you normally access them on the host, and what happens when you
> try the same thing inside the UML?
Normally I access them using minicom or chat/ppp. I can type AT commands or
set up
a ppp connection.
Using minicom inside UML (without workaround) just gives me a screen saying
"Welcome to minicom etc. etc.", but no commands can be entered.
In the chat case, same thing. No response to the AT command sent can be seen
in the syslog.
I made another interesting observation on one of my test systems. On this
specific system, the only way to get things running was to start minicom
outside and
inside of the UML simultaneously. As soon as both minicom sessions come up,
the modem
responds from inside UML. I then exit from both sessions - and everything's
fine...
/Magnus
-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________
User-mode-linux-user mailing list
User-mode-linux-user@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/user-mode-linux-user
