Hey Nikos, slots are only relevant for scheduling tasks. The number of outgoing channels depends on the number of parallel subtasks that consume a produced intermediate result stream, say the result of a source operator. If you have a job with a simple source->keyBy->map flow with parallelism X you will have X outgoing channels at the source operator, one for each consuming map subtask. This is what is exposed by the underlying channel selector.
For 1.1 the mentioned HashPartitioner should be called as you describe. In 1.2 this has been replaced by the KeyGroupStreamPartitioner. That the HashPartitioner method is not called is probably due to the fact that you are debugging this remotely. Have you tried it from within your local IDE, too? – Ufuk On Wed, Jan 25, 2017 at 2:12 PM, Katsipoulakis, Nikolaos Romanos <[email protected]> wrote: > Hello all, > > > > I have been looking into different StreamPartitioner<T> implementations of > Flink, and I noticed they come with an implementation of selectChannel(), as > defined in the ChannelSelector<T> interface. In order to understand better > the actions of a StreamPartitioner during execution, I set up Flink on a > single server with one TaskManager that had 16 slots. Then, I submitted a > job, with a HashPartitioner (through a keyBy() transformation), and remote > debugged it to see when the HashPartitioner’s selectChannel() method is > called. Unfortunately, the breakpoint is never reached and the job completes > successfully. Is the previous behavior normal? If yes, why is the breakpoint > never reached? Does it have to do with running the job in an environment > with local slots? Also, what determines the number of channels when a job is > executed? Does it have to do with the number of available slots in the > downstream operation of the partitioner? > > > > Thank you for your time and I appreciate any answers/comments/indications. > > > > Kind Regards. > > > > Nikos R. Katsipoulakis > > Department of Computer Science, > > University of Pittsburgh > >
