I have a cluster of RHEL machines (3 in total) and run Ignite 2.6 on them. The nodes seem to see each other since the visor shows them in the TOP command <http://apache-ignite-users.70518.x6.nabble.com/file/t2034/visor_-_top.jpg> so I want to join the nodes to a cluster. I run the ./control.sh --baseline command on one of the machines to see the list of the available nodes. The command gives me an empty list. -------------[root@adp-apachelg01 bin]# ./control.sh --baselineControl utility [ver. 2.6.0#20180710-sha1:669feacc]2018 Copyright(C) Apache Software FoundationUser: root--------------------------------------------------------------------------------Cluster state: inactiveCurrent topology version: 4Baseline nodes not found.----------------The question - what's wrong with it? Please find attached the config file which I use to start the nodes cluster-ignite.xml <http://apache-ignite-users.70518.x6.nabble.com/file/t2034/cluster-ignite.xml> cluster-default.xml <http://apache-ignite-users.70518.x6.nabble.com/file/t2034/cluster-default.xml> before running the nodes I ran the service.sh file to amend the firewall setting service.sh <http://apache-ignite-users.70518.x6.nabble.com/file/t2034/service.sh> ----------------------------Before running Ignite on the linux machines I did the same on the Windows machines - the ./control.sh --baseline command gave me the expected listing of the nodes and was able to join them in a cluster-----------------------One thing to note - I also did the following thing - I started the visor and a node (with the same config as above) on my Windows machine. The ./control.sh --baseline command listed me the running nodes. The visor showed my Windows nodesThen I started my Linux nodes. The control.sh command stopped to show the nodes. The TOP command in the Visor showed just my Linus nodes Please advise!!regards,Evgeny
-- Sent from: http://apache-ignite-users.70518.x6.nabble.com/
