You should be able to run the build inside Eclipse but you may need some
of the setup from
http://wiki.apache.org/lenya/HowToLenyaInEclipseDebugger to set up your
libraries and classpaths.
Ron
Renaud Richardet wrote:
Doug Chestnut wrote:
Josias Thoeny wrote:
On Wed, 2005-07-27 at 10:11 -0400, Doug Chestnut wrote:
Ron Wheeler wrote:
Good question. Did you try it and did it work?
I did not find any instructions about this approach but did see
the folder in the Lenya source distribution.
It would be great to have this documented. Specially if it works :-)
I think that there might be something missing from
http://wiki.apache.org/lenya/HowToLenyaInEclipseDebugger.
I tried to follow it on another Win XP PC with Eclipse after the
modification that I suggested had been included in the Wiki.
It did not work which means that a step is missing in the
instructions or I missed a step in following them. I did not have
time to find out which, so this is a bit of a warning.
If the eclipse-project works, then that would be much better.
Agreed, I couldn't get it to work when I tried it (ant
eclipse-project). It has been a while since I have tried though.
"ant eclipse-project" works for me, and I find it very convenient.
Do you remember what was your problem?
no, it has been a while. the steps in the wiki started with Gregor
helping me out via IRC. I will give eclipse-project a try.
eclipse-project works fine for me. I just made a small HowTo in the
wiki: http://wiki.apache.org/lenya/HowToLenyaInEclipse
Please have a look and check if it works for you. Maybe someone could
test if/how it works for the windows installer. Also, maybe Ant
doesn't even need to be installed if you build with the shell scripts,
I'm not sure.
HTH,
Renaud
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
