Hi, This may not be the suggested approach. I use it on my dev environments and it work OK.
Please edit the file $DCS_INSTALL_DIR/conf/servers There should be two lines there with the value 50 at the end of each line. Change the numbers as you wish. Save the file and copy it to the other node, at the same location. Stop DCS with dcsstop. Check all mxosrvrs are down with dcscheck. Start DCS with dcsstart. You should now see as many mxosrvrs as currently configured. Thanks Suresh On Sat, Jul 29, 2017 at 2:19 AM, Huang, Jack <[email protected]> wrote: > Hi Trafodioner, > > I installed the trafodion with the listed configuration. > > As a beginner, I set the dcs_cnt_per_node as 100 in my installation, and > sqlci display like this. > > After some testing, I found the count number is not enough for my testing. > > So the question is how can I change the number but did not any > re-installation? > > > > Process Configured Actual Down > > ------- ---------- ------ ---- > > DTM 2 2 > > RMS 4 4 > > DcsMaster 1 1 > > DcsServer 1 1 > > mxosrvr 100 98 2 > > RestServer 1 1 > > > > > > +------------------+---------------------------------------- > --------------------------+ > > | config type | value > | > > +------------------+---------------------------------------- > --------------------------+ > > | dcs_cnt_per_node | 100 > | > > | dcs_ha | N > | > > | first_rsnode | trafodion > | > > > > > > *Jack Huang* > > *Dell* *EMC* | CTD MRES Cyclone Group > > mobile +86-13880577652 > > [email protected] > > *[image: dell_emc_proven_badge_RGB_small]* > > > > > > >
