Hi Antonio,
Thanks for the reply. I was following the guide you mentioned and I'm stuck on
"Initial Administration Steps After Installing VCL", on step 2 where I should
create the base images.
I have done the "/usr/local/vcl/bin/vcld --setup" to capture the base image but
from there onwards it's not clear for me what I should do.
I tried following the guide regardless, but I am unable to see the base image
to create a new image from it when I log into VCL.
Thanks in advance for your assistance.
Regards,Luckmore Chirongo
From: António Aragão <[email protected]>
To: [email protected]; Luckmore Chirongo <[email protected]>
Sent: Friday, June 12, 2015 3:59 PM
Subject: Re: VCL setup question to Antonio Aragao
Hi Luckmore Chirongo,
My VCL installation is: 2.3.2
I used this guide: https://vcl.apache.org/docs/VCL232InstallGuide.html
Remember:
I use:
1 virtual machine for vclnode1 (this virtual machine exports to ESXi host using
NFS vcl images)
1 virtual machine for vclweb1 (the frontend)
1 virtual machine for vclgateway1 (this gives the machines internet access)
1 ESXi 5.5 host (this virtual machines resides on this host)
1 virtual network (public) - 192.168.93.X
1 virtual network (private) - 10.100.0.X
I think it is all. Can you tell what step you are stuck ?
Regards,
2015-06-09 15:08 GMT+01:00 Luckmore Chirongo <[email protected]>:
Hi Antonio,
I have seen the setup you mentioned to be using. It is the same one I would
like to do, but I have struggled to complete the installation to a working
system.
May you please send me a step by step installation guide that you used. I have
struggled to get one - even the documentation gets unclear at the point just
after creating base images.
Thanks in advance and regards,Luckmore Chirongo
--
