Hello David,

Yes, that shows that it is working.

Kind regards
Noel

Am 28.07.21 um 22:31 schrieb David H Durgee:
I did a bit more checking and found references to "ip xfrm policy list" and "ip xfrm 
state list" as possible sources of the confirmation of operation I am seeking.  I ran these 
commands with the VPN up and have attached the output of these commands.

I am not trained in reading these reports, but what I see does appear to 
indicate that the VPN is indeed functioning and handling the traffic as 
requested.  If someone who is trained could confirm this for me I would 
appreciate it.

Dave

Noel Kuntze wrote:  Hello David,

strongSwan by default builds policy based tunnels, not route based tunnels.
Thus no interface is needed or created.
Read up on how IPsec works on the wiki to get an understanding for it.

GUI indicators are not inherently related to if any tunnel exists, or works.

Kind regards
Noel

Am 01.07.21 um 20:31 schrieb David H Durgee:
I thought it might make sense to revisit this after the progress that has been 
made. It now appears that the connection is being established:

Jun 29 11:21:34 Z560 charon-nm: 11[IKE] authentication of 
'durgeeenterprises.publicvm.com' with EAP successful
Jun 29 11:21:34 Z560 charon-nm: 11[IKE] IKE_SA Durgee Enterprises, LLC[7] 
established between 
192.168.1.114[dhdurgee]...108.31.28.59[durgeeenterprises.publicvm.com]
Jun 29 11:21:34 Z560 charon-nm: 11[IKE] scheduling rekeying in 35705s
Jun 29 11:21:34 Z560 charon-nm: 11[IKE] maximum IKE_SA lifetime 36305s
Jun 29 11:21:34 Z560 charon-nm: 11[IKE] installing new virtual IP 10.10.10.1
Jun 29 11:21:34 Z560 avahi-daemon[750]: Registering new address record for 
10.10.10.1 on wlp5s0.IPv4.
Jun 29 11:21:34 Z560 charon-nm: 11[CFG] selected proposal: 
ESP:AES_CBC_256/HMAC_SHA1_96/NO_EXT_SEQ
Jun 29 11:21:34 Z560 charon-nm: 11[IKE] CHILD_SA Durgee Enterprises, LLC{4} 
established with SPIs c8cad4e5_i c3f2eec4_o and TS 10.10.10.1/32 === 0.0.0.0/0
Jun 29 11:21:34 Z560 charon-nm: 11[IKE] peer supports MOBIKE
Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.6991] 
vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, 
LLC",0]: VPN connection: (IP Config Get) reply received.
Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.6997] 
vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, 
LLC",0]: VPN plugin: state changed: started (4)
Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.6997] 
vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, 
LLC",0]: VPN connection: (IP4 Config Get) reply received
Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7003] 
vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, 
LLC",0]: Data: VPN Gateway: 108.31.28.59
Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7003] 
vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, 
LLC",0]: Data: Tunnel Device: (null)
Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7003] 
vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, 
LLC",0]: Data: IPv4 configuration:
Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7003] 
vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, 
LLC",0]: Data:   Internal Address: 10.10.10.1
Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7004] 
vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, 
LLC",0]: Data:   Internal Prefix: 32
Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7004] 
vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, 
LLC",0]: Data:   Internal Point-to-Point Address: 10.10.10.1
Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7004] 
vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, 
LLC",0]: Data:   Internal DNS: 8.8.8.8
Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7004] 
vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, 
LLC",0]: Data:   Internal DNS: 8.8.4.4
Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7004] 
vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, 
LLC",0]: Data:   DNS Domain: '(none)'
Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7004] 
vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, 
LLC",0]: Data: No IPv6 configuration
Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7013] 
vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, 
LLC",0]: VPN connection: (IP Config Get) complete

Unfortunately I am not seeing a tunnel interface being created and routing 
added:

enp6s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        ether b8:70:f4:2c:6b:9f  txqueuelen 1000  (Ethernet)
        RX packets 1143393  bytes 1164336056 (1.1 GB)
        RX errors 0  dropped 20  overruns 0  frame 0
        TX packets 912738  bytes 112966285 (112.9 MB)
        TX errors 0  dropped 0 overruns 0  carrier 0 collisions 0

lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        inet6 ::1  prefixlen 128  scopeid 0x10<host>
        loop  txqueuelen 1000  (Local Loopback)
        RX packets 95404  bytes 9207887 (9.2 MB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 95404  bytes 9207887 (9.2 MB)
        TX errors 0  dropped 0 overruns 0  carrier 0 collisions 0

wlp5s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
        inet 192.168.1.114  netmask 255.255.255.0  broadcast 192.168.1.255
        inet6 fe80::562f:7604:6d84:57ca  prefixlen 64 scopeid 0x20<link>
        ether ac:81:12:a4:5e:43  txqueuelen 1000  (Ethernet)
        RX packets 5644  bytes 4264877 (4.2 MB)
        RX errors 0  dropped 0  overruns 0  frame 62520
        TX packets 6377  bytes 1007195 (1.0 MB)
        TX errors 0  dropped 0 overruns 0  carrier 0 collisions 0
        device interrupt 17

dhdurgee@z560:~/Downloads$ route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref Use Iface
default         _gateway        0.0.0.0         UG    20600 0        0 wlp5s0
link-local      0.0.0.0         255.255.0.0     U     1000 0        0 wlp5s0
192.168.1.0     0.0.0.0         255.255.255.0   U     600 0        0 wlp5s0
dhdurgee@z560:~/Downloads$

In case it is needed for reference, here is the ipsec.conf on the server side:

config setup
  charondebug="ike 1, knl 1, cfg 1"
  uniqueids=no

conn ikev2-vpn
  auto=add
  compress=no
  type=tunnel
  keyexchange=ikev2
  fragmentation=yes
  forceencaps=yes
ike=aes256-sha1-modp2048,aes256-sha1-modp1024,3des-sha1-modp1024!
  esp=aes256-sha1,3des-sha1!
  dpdaction=clear
  dpddelay=300s
  rekey=no
  left=%any
  leftid=@durgeeenterprises.publicvm.com
  leftcert=/etc/ipsec.d/certs/vpn-server-cert.pem
  leftsendcert=always
  leftsubnet=0.0.0.0/0
  right=%any
  rightid=%any
  rightauth=eap-mschapv2
  rightsourceip=10.10.10.0/24
  rightdns=8.8.8.8,8.8.4.4
  rightsendcert=never
  eap_identity=%identity

Here is the connection definition from /etc/NewtorkManager/system-connections:

[connection]
id=Durgee Enterprises, LLC
uuid=72e4370d-ecfb-4e33-8572-5cf04431abb9
type=vpn
autoconnect=false
permissions=user:dhdurgee:;

[vpn]
address=durgeeenterprises.publicvm.com
certificate=/home/dhdurgee/Downloads/vpn_root_certificate.pem
encap=no
ipcomp=no
method=eap
password-flags=1
proposal=no
user=dhdurgee
virtual=yes
service-type=org.freedesktop.NetworkManager.strongswan

[ipv4]
dns-search=
method=auto

[ipv6]
addr-gen-mode=stable-privacy
dns-search=
ip6-privacy=0
method=auto

[proxy]

The listed connection was created via the GUI.  I have screenshots of the four 
pages from the GUI available for email as they violate size restrictions of 
posting here..

As the VPN connection is already working with android and windows systems I 
want to make no changes to the ipsec.conf on the server. All changes should be 
made to the linux connection.

I can only assume there are revisions to be made, hopefully via the GUI.  
Obviously if the GUI cannot address what is needed I can edit the connection 
directly.

Alternatively, am I misunderstanding what I am seeing and the tunnel is 
actually being established?  I see only the WiFi icon on the bar at the bottom 
of the screen just as I do when opening the WiFi connection. With another VPN 
service, now discontinued, I showed a different icon indicating the secured 
tunnel was open.  This other discontinued service likewise created a tun 
interface and established a route via that interface.

If more information is required please let me know.

Dave






Attachment: OpenPGP_signature
Description: OpenPGP digital signature

Reply via email to