Hi Thomas,
i guess there is a way to control this in a friendly way. Note that when
there is nothing in the inuser field, this falls to default behaviour
which is anonymous group. When a group name [or a comma separated list
of group names] is specified, this means its only accessible to these
groups and anonymous group has be specified explicitly if its needed.
Now, to make mass assignments, you can always do a multi-select (select
one and hold the shift key and arrow key) and then edit the inuser
field, this will apply to all the selected attributes/filters.
HTH,
Syed
On 06/01/2012 19:36, Thomas TRIPLET wrote:
Greetings,
I have created a new group of users and would like to enable this group to use
access points (AP) already created or new ones. When the group is active, the
little (C) icon before the name is green, meaning that the AP should be active
for the group of users. In the webpage, the users can indeed view the AP.
However, the attribute and filter sections are empty, with nothing listed.
A quick investigation showed me that in order for the attributes/filters to
appear in the GUI, I should also type the name of the group in the parameter
inusers for each of the attributes in order to appear on the web page.
Although possible it is extremely cumbersome to document that parameter for
each attribute as I have hundreds of them... Besides, the anonymous group does
not seem to be affected by this behavior as those anonymous users can view all
the attributes even though the inusers param does not reference the anonymous
group. Is there a way to change this behavior or at least automate it (e.g.
automatically fill in the param for all attributes when the AP is activated)?
Thanks
Thomas
Thomas Triplet, Ph.D.
http://www.thomastriplet.net
Centre for Structural and Functional Genomics
Concordia University
7141 West Sherbrooke St
Montreal QC H4B 1R6
_______________________________________________
Users mailing list
[email protected]
https://lists.biomart.org/mailman/listinfo/users
