Hi All, I added a new subnet to a new pod. I think it should produce a new vrouter, when I added new vms. But it is not what I expect, my old ips on old pods almost exhaust, so I worried. Who can help me? Thank you.
Steven On 12/12/2013 02:39 PM, Steven Liang wrote: > Hi Brandon, > > Thank you for your updating. > I didn't use vlan, and I've added the new ip subnet to a new pod of my > cs. After added some vms, there is no vms assign new ips. I need to > configure vrouter manually? > Thank you. > > Steven > > > On 12/12/2013 12:27 PM, Brandon Arms wrote: >> Here is the citrix answer: >> >> Extending your IP range >> If you want to extend the range. You can add another IP range by clicking on >> Add IP Range and then specify the same network & VLAN settings, except >> specify the a new IP range in the same subnet. Do not overlap the existing >> public IP range. >> >> The issue I found is my current public ip range is limited by my current >> subnet mask. For example, if your public range is something like this: >> Gateway: 1.1.1.1 >> Netmask: 255.255.255.224 >> Vlan: 10 >> Startip: 1.1.1.2 >> endIP: 1.1.1.30 >> >> I cannot extend my range as I only have 32 addresses available per my subnet >> mask, so the citrix solution is not an option. >> >> I assume the citrix solution is valid if you have something defined like >> this: >> Gateway: 1.1.1.1 >> Netmask: 255.255.255.0 >> Vlan: 10 >> Startip: 1.1.1.2 >> endIP: 1.1.1.30 >> >> now you have 256 possible ip addresses per your mask, but are only allowing >> a subset of those to be assigned. >> >> I think in my case, I would have to find where this information is kept in >> the DB, and modify my subnet mask first, and then proceed with extending via >> the citrix solution. The other option is to just add another vlan/subnet >> for the system account to use versus trying to extend your current one. >> >> Brandon Arms >> DSS >> >> -----Original Message----- >> From: Steven Liang [mailto:stevenli...@yesup.com] >> Sent: Thursday, December 12, 2013 11:17 AM >> To: users@cloudstack.apache.org >> Subject: how to add new public subnets to my cs(basic networking mode) >> >> Hi everyone, >> >> Could you please tell me how to add new public subnets to my cs? Because my >> existing ips will exhausted. >> Thank you. >> >> Regards, >> Steven >> >>