Hi Swen, no issues, since external Juniper router is doing the routing between multiple public IP ranges - here is my setup inside ACS, check it: https://snag.gy/kp67WA.jpg (ACS multiple ranges)
each of this "gateway" address is an interface on Juniper (btw, I don't manage it, my colleague does) and rest of the range is given to ACS for use. So if 2 VRs are in different IP ranges, traffic between them will flow VR1--> JUNIPER --> VR2 Hope that helps Andrija On Mon, 23 Jul 2018 at 14:15, Swen - swen.io <[email protected]> wrote: > Hi Andrija, > > did you have routing problems when a VR is using IPs out of more than one > ip range? > > Best regards, > Swen > > -----Ursprüngliche Nachricht----- > Von: Andrija Panic [mailto:[email protected]] > Gesendet: Mittwoch, 18. Juli 2018 16:49 > An: users <[email protected]> > Betreff: Re: add new ip range to zone > > Bunch of Public IP ranges, again in same VLAN... (gateway is just an > virtual inteface on physical router...all virtual interfaces in same vlan) > > On Wed, 18 Jul 2018 at 14:28, Nicolas Bouige <[email protected]> wrote: > > > Hi Rafael, > > > > yes, we had the situation but both ranges of public IPs was already in > > the same VLAN. > > > > Nicolas Bouige > > DIMSI > > cloud.dimsi.fr<http://www.cloud.dimsi.fr> > > 4, avenue Laurent Cely > > Tour d’Asnière – 92600 Asnière sur Seine T/ +33 (0)6 28 98 53 40 > > > > > > ________________________________ > > De : Rafael Weingärtner <[email protected]> > > Envoyé : mercredi 18 juillet 2018 13:02:41 > > À : users > > Objet : Re: add new ip range to zone > > > > Nicolas, have you had the situation where 2 public IPs from different > > ranges were assigned to the same VPC(VR)? > > Here we had this situation, and it was not playing well in our network > > setup. We had to move everything to the same VLAN. > > > > On Wed, Jul 18, 2018 at 7:25 AM, Nicolas Bouige <[email protected]> > wrote: > > > > > Hello Swen, > > > > > > In our deployment, we are using two different network for public ip in > > the > > > same vlan without any problem. > > > > > > Best regards, > > > N.B > > > > > > -----Message d'origine----- > > > De : Swen - swen.io [mailto:[email protected]] > > > Envoyé : mercredi 18 juillet 2018 11:26 > > > À : [email protected] > > > Objet : add new ip range to zone > > > > > > Hello all, > > > > > > We are using advanced networking in our installation and we need to add > > > new public ips. > > > Should we configure the new /24 network in the same vlan as the other > one > > > or should we use a vlan-id for each /24 network? What do you recommend? > > > > > > I am concerned what is happening if a VR gets public ips from different > > > /24 networks within the same or in different vlans? Is there a chance > > that > > > a routing problem of any kind will accrue? > > > > > > Thank you for your 2 cents (or more) on this! > > > > > > Best regards, > > > Swen > > > > > > > > > > > > > > > > > > -- > > Rafael Weingärtner > > > > > -- > > Andrija Panić > > > -- Andrija Panić
