You are absolutely right; after reinstalling the new virtual hard disk, I had forgotten to do that again. I'll proceed with the earlier instructions from here.
Ludo www.potingue.be On Sat, Mar 29, 2014 at 9:00 AM, karu.pruun <[email protected]> wrote: > On Fri, Mar 28, 2014 at 11:40 PM, Ludo Beckers wrote: > > Since that page says: <<To ensure *pkgng* on a DragonFly BSD 3.4 or >> higher system is ready for use, run the following BEFORE you try to use >> pkg the first time:>> >> >> I took out the DragonFly from the VM and loaded it fresh. >> >> Then after >> >> # cd /usr >> # make dports-create >> I'm stuck with a message that says it could not create work tree dir >> '/usr/dports'. >> : Read-only file system*** Error code 128 >> >> > Just to check: did you actually create a new virtual hard disk and install > DFly on that or are you running the live cd in your VM? If the latter, then > you cannot write anything on it; you can't install any packages since that > live cd is a read-only filesystem. > > Peeter > > -- > > > > > >
