On Fri, Oct 31, 2014 at 1:02 AM, Sascha Wildner <[email protected]> wrote:
> On Thu, 30 Oct 2014 04:09:05 +0100, Mehmet Erol Sanliturk < > [email protected]> wrote: > > Dears All , >> >> >> During installation of DragonFly 4.0.0 RC , the following points may >> require improvement : >> >> >> 1. USB network cards are NOT recognized during install boot and >> configuration ( and after >> reboot in 3.8.2 by ifconfig ) >> > > There could be 2 reasons I can think of: > > * If it is a USB3 port, the port might not work at all until xhci(4) is > loaded. We don't load xhci by default (but I really think we should start > doing so). > > * The adapter is not supported. Right now, we have only 2 drivers (3, if > you count urndis(4)): axe(4) and udav(4). > > What adapter is it that you have? > > Sascha > Port is USB 2.0 . Adapter is : http://www.digitus.info/en/products/network/fast-ethernet-network/network-interface-cards/ http://www.digitus.info/en/products/network/fast-ethernet-network/network-interface-cards/fast-ethernet-usb-20-adapter-dn-10050/ FreeBSD 8 is NOT recognizing but FreeBSD 9 and 10 are recognizing it . Thank you very much . Mehmet Erol Sanliturk
