Hi Erik, Thanks for your suggestion. I was doing a sim run because I get this error when I *start a new simulation* doing a 'submit' on my cluster "Executing submit command: exec nohup <sim directory address>". Which made me think 'submit' cannot be used when submitting a job to a cluster; rather it can be used only when running a sim on the front end (to hide the output from the terminal).
Anyway, now as I am doing a *restart* using 'submit' I am getting these messages and then the simulation stops. Warning: Simulation nsnstohmns_low_resolution_Marronetti already has an active submission. Chaining this submission onto job id 999999 Warning: job status is U Warning: Job chaining requested but job id 999999 is not in the queue. Its status is U. Aborting submission. I guess the issue is with the "status is U" part now. Best regards, Atul. On Sat, Aug 15, 2020 at 8:57 PM Erik Schnetter <schnet...@cct.lsu.edu> wrote: > Atul > > "sim run" starts a simulation right away. Have you tried "sim submit" > instead? This should check whether the simulation is still active, and > if so, deactivate it before running the next restart. > > -erik > > On Sat, Aug 15, 2020 at 7:54 PM Atul Kedia <ake...@nd.edu> wrote: > > > > Hello, > > > > I want to restart a simulation to make it run for longer. It currently > stopped at the time it was asked it at my par file. It has checkpoints > enabled in the par file. > > > > I have increased the time in the par file at <sim_name>/output-0000/ and > at <sim_name>/SIMFACTORY/par and I tried the commands : > > > > simfactory/bin/sim cleanup <sim_name> > > followed by > > simfactory/bin/sim run <sim_name> > > and set the added a line "jobid = 999999" as suggested at : > http://lists.einsteintoolkit.org/pipermail/users/2018-September/006528.html > > > > and I get the error message : > > "Error: Internal error: Cannot submit simulation <sim_name> because it > is already active" > > > > Another email thread I used for reference was this one: > http://lists.einsteintoolkit.org/pipermail/users/2018-May/006281.html > > > > I am using ET_Mayer with the default simfactory that it comes with > (simfactory 2, I think). > > > > Any help would be really appreciated. > > > > Thank you, > > > > -- > > Atul Kedia > > PhD student, > > Physics department, > > University of Notre Dame. > > _______________________________________________ > > Users mailing list > > Users@einsteintoolkit.org > > http://lists.einsteintoolkit.org/mailman/listinfo/users > > > > -- > Erik Schnetter <schnet...@cct.lsu.edu> > http://www.perimeterinstitute.ca/personal/eschnetter/ > -- Atul Kedia PhD student, Physics department <http://physics.nd.edu/>, University of Notre Dame.
_______________________________________________ Users mailing list Users@einsteintoolkit.org http://lists.einsteintoolkit.org/mailman/listinfo/users
