Hi all,
when you do "qstat" or "qstat -r" you get a string representing the
current job state ("r", or "qw", or ...). If you try to specify a
specific job with the "-j" flag you get the long version where the state
disappears (if you look hard enough you can figure out if a job is
running by the i/o info, other states are not quite so obvious). Is
there a way to get the same output of "qstat" or, even better, "qstat
-r" for a specific job ?
Thanks,
--
Valerio Luccio (212) 998-8736
Center for Brain Imaging 4 Washington Place, Room 158
New York University New York, NY 10003
"In an open world, who needs windows or gates ?"
_______________________________________________
users mailing list
[email protected]
https://gridengine.org/mailman/listinfo/users
