Hi,
I'm configuring my mandrake box to support ipv6 for the very first time, I
got almost everything ready, configuration apps, tools,scripts,etc.
I'm configuring the scripts and I have some questions about the values I got
to put in them, I don't understand quite well what I have to do in some parts
(maybe for my bad english) so I hope some here can explain me:
In
/etc/sysconfig/network-scripts/ifcfg-eth0(normal network interface):
Enable/disable IPv6 configuration for this interface:
#IPV6INIT="yes" # Initalize IPv6 "yes"
IPV6INIT="no" # Initalize IPv6 "no"Enable/disable
IPv6 forwarding on this interface:
#IPV6FORWARDING="yes" # Control {yes|no} forwarding through
this device
IPV6FORWARDING="no" # Control {yes|no} forwarding through
this device
'Yes' is commented by default, but in the howto doesn't says anything if
leaving it commented or not. The same happens in
/etc/sysconfig/network-scripts/ifcfg-sit1(IPv6 in IPv4 tunnel interface).
And in /etc/sysconfig/network-scripts/ifcfg-sit1(IPv6 in IPv4 tunnel
interface), where I specify the primary ipv6 route through the tunnel has an
example ipv6 address of 3ffe::/16, and the one I got from freenet6.net was
much longer, 3ffe:b00:c18:1fff:0:0:0:f0. I got to put that ip in there or in
the additional static routes file?
Sorry for the lame cuestion.
--
>>>NEXT MEDIA INTERACTIVE<<<
Juan Luis Baptiste
Ingeniero de Desarrollo
Email: [EMAIL PROTECTED]
Dir: Calle 98 #9-03 Piso 2
Tel: 57 1 2188888 Ext. 340
BOGOTA - COLOMBIA
---------------------------------------------------------------------
The IPv6 Users Mailing List
Unsubscribe by sending "unsubscribe users" to [EMAIL PROTECTED]
