Hi!
I have set up an IPv6 only host by configuring eth0 with IP
address 0.0.0.0. However apparently, X doesn't recognize an IPv6 address
as a legal DISPLAY variable value and so I am stuck if I want to remotely
connect to some other IPv6 enabled m/c from this host and run an
X-application.
Are there any X implementations that accept v6 addresses in
DISPLAY variable values???
Thanks in advance.
Vartika
--
*******************************************************************************
Vartika Bhandari E-mail :
Senior Undergraduate (CSE) [EMAIL PROTECTED]
Room No. D209/GH [EMAIL PROTECTED]
I.I.T Kanpur. [EMAIL PROTECTED]
*******************************************************************************
---------------------------------------------------------------------
The IPv6 Users Mailing List
Unsubscribe by sending "unsubscribe users" to [EMAIL PROTECTED]
