-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
- --On Thursday, May 23, 2002 11:00:19 AM +0200 Michael Kjorling
<[EMAIL PROTECTED]> wrote:
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
>
> On May 23 2002 08:26 +0200, Jean-Mickael Guerin wrote:
>
>> Hello,
>> Does anyone know how to configure IPv4-in-IPv6 tunnels on linux, if
>> possible ?
>> I use linux 2.4.18
>
> Set up a "pointopoint" interface with an IPv6 remote endpoint, and
> route all IPv4 traffic through it? (route -A inet add inet dev
> ${IF})
>
> I'm just guessing, but that's how I would most likely try it.
Are you sure that will work?
"ip" don't support IPv6 addresses in tunnel mode:
# ip tunnel help
Usage: ip tunnel { add | change | del | show } [ NAME ]
[ mode { ipip | gre | sit } ] [ remote ADDR ] [ local ADDR ]
[ [i|o]seq ] [ [i|o]key KEY ] [ [i|o]csum ]
[ ttl TTL ] [ tos TOS ] [ [no]pmtudisc ] [ dev PHYS_DEV ]
"remote" and "local" are IPv4 only.
Afaik, USAGI is working on IPv4|6 over IPv6, therefore I'm sure it's
not working on current vanilla kernels.
Peter
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.6 (GNU/Linux)
iD8DBQE87WL4e1eqe5WPQi0RAi5xAKCQYaKUNSFqk8JKcqKHcxVcTVEduwCg6kn+
dnvPY5AeFfuSPO7wfEOFekk=
=SlM6
-----END PGP SIGNATURE-----
---------------------------------------------------------------------
The IPv6 Users Mailing List
Unsubscribe by sending "unsubscribe users" to [EMAIL PROTECTED]
