Hi,
fakesmsc is for testing purposes. So it make no sense that it will
support throughput config option. In short: fakesmsc doesn't support
throughput config option.
Thanks,
Alex
Gulshan Babajee schrieb:
Hi, am also facing the same problem as Ankur. I configured the throughput
variable in the config file
like this: throughput = 1, but the SMSC receive msg at a rate of about
3msg/sec. The only difference is that
am testing this with 'FAKESMSC' in Kannel, not a real one. Should it make a
difference?
Thanks in advance
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Stipe Tolj
Sent: Friday, February 10, 2006 4:12 AM
To: Ankur Bhatnagar
Cc: Kannel Users
Subject: Re: throughput parameter not working
Ankur Bhatnagar wrote:
Apparently, this is a common problem faced by many users. In spite of
searching the list archive, I could not get a clear direction. So I am
posting it here.
My SMSC can take messages up to the rate of 7 msg/sec but my gateway
(Kannel
1.4) sends the messages at approximate rate of 30 msg/sec. I tried setting:
throughput = 7 msg /sec
But this setting doesn't seem to have any effect at all. The
throughput is not reduced. Do I need to set some parameters?
did you enter the config directive that way? including the "7 msg /sec" as
value? If yes, this won't work.
If you have 'throughput = 7' this should be working working.
Please do:
a) use cvs version
b) post the debug log level that shows us how fast Kannel tries to send messages
towards the SMSC.
Stipe
-------------------------------------------------------------------
Kölner Landstrasse 419
40589 Düsseldorf, NRW, Germany
tolj.org system architecture Kannel Software Foundation (KSF)
http://www.tolj.org/ http://www.kannel.org/
mailto:st_{at}_tolj.org mailto:stolj_{at}_kannel.org
-------------------------------------------------------------------
