Kannel needs direct access to the modem AT port (ttyACM0) if your driver does not allow this, you are out of luck unless you develop a middleware that will sit between kannel and your g3 card. Or maybe it allows http access?
are you able to send sms? add log-file = /yourpath/modem.log log-level=0 to your smsc-at config and post log |-----------------------------------------------------------------------------------------------------------------| Envíe y Reciba Datos y mensajes de Texto (SMS) hacia y desde cualquier celular y Nextel en el Perú, México y en mas de 180 paises. Use aplicaciones 2 vias via SMS y GPRS online Visitenos en www.perusms.NET www.smsglobal.com.mx y www.pravcom.com On Tue, Dec 21, 2010 at 11:51 PM, parimal naigaonkar <[email protected]> wrote: > hi, > i have a 3g data card, it is detected on ttyACM0 only when i run the package > given in it for linux. > i am able to configure and use it to send messages but kannel is not able to > receive messages instead the package itself receives messages and shows pop > up. > ---------------------------------------------------------------------------------------------- > output of dmesg: > [ 3199.311902] sr 4:0:0:0: [sr1] Unhandled sense code > [ 3199.311904] sr 4:0:0:0: [sr1] Result: hostbyte=DID_OK > driverbyte=DRIVER_SENSE > [ 3199.311907] sr 4:0:0:0: [sr1] Sense Key : Medium Error [current] > [ 3199.311910] sr 4:0:0:0: [sr1] Add. Sense: Unrecovered read error > [ 3199.311913] sr 4:0:0:0: [sr1] CDB: Read(10): 28 00 00 00 20 ca 00 00 02 > 00 > [ 3199.311920] end_request: I/O error, dev sr1, sector 33576 > [ 3442.367533] usb 2-6: USB disconnect, address 7 > [ 3442.367961] ehci_hcd 0000:00:1d.7: dma_pool_free buffer-2048, > ed830080/2d830080 (bad dma) > [ 3442.401478] scsi 4:0:0:0: rejecting I/O to dead device > [ 3460.816207] usb 2-6: new high speed USB device using ehci_hcd and address > 8 >
