On 01/11/12 13:27, Edion Tego wrote: > > Thank you i thought i had installed all the modules requested > > Now I have completed the installation, and opened lisp, but I think I > might have configured something wrong. > > > > Because it says: /Installed’ negative’ map cache entry using PETR as > the locator./ >
This is not an error, you get this message whenever you try to contact a non-LISP destination. For example, you probably have a DNS server configured, which is not a LISP destination. Your node will contact this server using a Proxy ETR. > > > /Also it says: Destination 153.x.x.112/ > > / Not default route, ignored/ > Not an error message per se either. > > > And our site does not appear on the lispmon.net <http://lispmon.net/>, > but on http://www.lisp4.net/lisp-site/#uniroma-xtr, we are active via > proxy. > When you say it doesn't appear on lispmon.net, you mean the map, or the looking glass? The map is only updated once a day, so you need to keep your mobile node connected for at least one day. The scanning is done ususally at 9AM Central European Time. If you mean the looking glass, than you have a different problem, you are not correcly registered in the mapping system. However, I just checked, and I get the following mapping: # lig uniroma-xtr.lisp4.net Send map-request to 85.184.2.42 for uniroma-xtr.lisp4.net ... Received map-reply from 195.50.116.18 with rtt 0.05900 secs Mapping entry for EID '153.16.44.113': 153.16.44.112/28, via map-reply, record ttl: 10, not auth, not mobile Locator State Priority/Weight 151.100.122.9 up 1/100 So you host is correctly registered with the mapping system, as http://www.lisp4.net/lisp-site/#uniroma-xtr says. > > > The section : > > > > /# Static cache entries/ > > /static-map-cache {/ > > / eid-prefix = 153.x.x.112/24 #here > <http://153.16.44.112/24#here> I put my EID/ > > / rloc = 151.s.x.9 #Here my RLOC/ > > / priority = 1/ > > / weight = 100/ > > /}/ > > > > I this conf ok, or I have to put and the mask of the RLOC, or > something else entirely? > You should not have static map-cache entries configured under normal circumstances. > > > Also, I’d like to ask if it is any way to insert the DNS in the > configuration, because I do not have internet access, even that at the > lisp site status our site shows active, but it does not appear on the > map of lispmon.net <http://lispmon.net> > I see now, you meant the lispmon.net map. See above why you don't show up on that yet. DNS should work, if you have a correct Proxy-ETR configured, and the Proxy-ITR handling your prefix has no issues. You have control over the first one, but not over the second one. The way I see it, you have a /28 LISP prefix, which are used for non-mobile sites. Mobile nodes on the beta network are allocated /32 prefixes from a different address range. I will allocate a new EID for your LISPmob tests. > Also I wanted to configure more than one map resolver and map server, > how do I do that? > This is not fully supported yet, all testing was done with a single Map-Resolver and Map-Server so far. > > > Thank you for your time and patience > Sure, no prob. ;) > > > Sorry for the trouble > No trouble at all. -Lori > > > Bye >
