HI. I want to try LISPd in my openwrt router CC chaos calmer 15.05
I have Buffallo WZR-1750DHP router with openwrt, I install LISPD by opkg
update, opkg install lispd
my openwrt router is not atheros ar71x but (BCM4708) kernel version 3.18.20
I would like to use LISPD as I want MULTIHOMING I have 3 wan phisical
interfaces in router isolated as vlans
so I have some questions and hope you can help me..
1- LISPD multihoming add bandwidth from all my wans? ex wan=
12mbpsDOWN/2mbpsUP
wan2 = 7mbpsDown/3mbpsUP wan3 = 10mbpsDown/4mpbsUP so these 3 would add
the bandwidth like bonding and have 29mbpsDown/9mpsUP ???
2-I install the version 4.1 of LISPD in openwrt that was in the update
software so with this version I would have multihoming enable ?
3- per automatic config is recomended to put this
add the following lines to `/etc/sysctl.conf`. Remember to
reboot your system after adding these lines.
net.ipv4.conf.default.rp_filter=0
net.ipv4.conf.all.rp_filter=0
net.ipv4.ip_forward=1
net.ipv6.conf.all.forwarding=1
but my openwrt LISPD version is diferent here how it is NOTE that it is not
rp_filter=0 but arp_ignore=1 and what should I put here 0 or 1 ? default
is 1
and note2 instead of all.rp_filter=0 it said all.arp_ignore=1
kernel.panic=3
net.ipv4.conf.default.arp_ignore=1
net.ipv4.conf.all.arp_ignore=1
net.ipv4.ip_forward=1
net.ipv4.icmp_echo_ignore_broadcasts=1
net.ipv4.icmp_ignore_bogus_error_responses=1
net.ipv4.igmp_max_memberships=100
net.ipv4.tcp_ecn=0
net.ipv4.tcp_fin_timeout=30
net.ipv4.tcp_keepalive_time=120
net.ipv4.tcp_syncookies=1
net.ipv4.tcp_timestamps=1
net.ipv4.tcp_sack=1
net.ipv4.tcp_dsack=1
net.ipv6.conf.default.forwarding=1
net.ipv6.conf.all.forwarding=1
net.netfilter.nf_conntrack_acct=1
4- It said that I should add all my interfaces before activating, so my
question is how I put the interfaces and how to set routes ?
could you set this for me.. since I am very newbie with this ... here my
data for interfaces
NOTE: wan's are in order of importance for the metrics... wan is the most
important then wan2 and less important is wan3
LAN= eth0.1 =ip 192.168.10.1
WAN= eth0.2 =ip is DHCP in 192.168.2.192/24
WAN2= eth0.200 =ip is DHCP in 192.168.11.192/24
WAN3= eth0.300 =ip is DHCP in 192.168.8.50/24
once made this the system would work out of the box ? or need something ?
5- I have use mwan3 and multiwan but it seems it only do load balancing but
not add the bandwidth of all wans.... what would be the advantages of
multihoming vs mwan3 and multiwan if any ?
thanks so much in advance
Joseph Colin
--
