And, You can also take care of the details in the following thread:
http://list.opensaf.org/archives/users/2007-December/000686.html - Mathi. > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of > Mathivanan Np-G19859 > Sent: Tuesday, December 18, 2007 3:54 PM > To: John Callow; [email protected] > Subject: Re: [Users] ncs_cli_maa problems > > John, > > These errors indicate that the CLI request got timedout. > Basically these CLI requests are forwarded to MASV which > inturn forwards to the AVSV module which processes the requests. > When these CLI requests fail, there should be an indication > of the reason why these failed in the log files of MASV**.log > and AVD**.log > > You could check them. Let know if you are still unable to makeout. > > Regards, > Mathivanan. > > > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED] On Behalf Of John Callow > > Sent: Tuesday, December 18, 2007 1:12 AM > > To: [email protected] > > Subject: [Users] ncs_cli_maa problems > > > > Hello all, > > > > I've recently returned to the world of OpenSAF after > working on some > > other stuff. In the time I was diverted OpenSAF moved from > 1.0-2 to > > 1.0-4. After upgrading my OpenSAF installation I'm seeing some > > problems using the avsv CLI, namely: > > > > # /opt/opensaf/controller/bin/ncs_cli_maa > > > > cli idle time is 300 seconds > > ncs cli user is an authenticated super user. > > NCS>enable > > NCS#configure terminal > > NCS-config#avsv > > NCS-config-avsv#set safNode=PL_2_4 adminstate unlocked > MIB_ARG PP @ > > address b4dbe7f0 ================================= > > Op: SET Req, Tbl Id: 11, Exch Id: 0 > > User Key: 4288675841 > > MIB Key: 4288675841 > > Source: 4 > > Index vals as int: , 14, 115, 97, 102, 78, 111, 100, 101, > 61, 80, 76, > > 95, 50, 95, 52 Index vals as ascii: , , s, a, f, N, o, d, > e, =, P, L, > > _, 2, _, 4 Param Val: Id 4, Integer, Val 2 IN > LEAP_DBG_SINK: line 518, > > file ./src/hj_mib.c IN > > LEAP_DBG_SINK: line 253, file ./src/hj_mib.c > > > > FAILURE: State could not set > > ..... Command Execution Function failed ..... > > > > > > Basically, all 'set' commands give the same error. This > seems fairly > > 'random' at the moment, in that if I reboot OpenSAF on all > nodes (inc. > > controller), next time the same commands work. It seems to be > > happening about 1/2 the time I start OpenSAF. > > > > Any ideas on how to diagnose what's causing it? > > > > Thanks and regards, > > > > John > > > > _______________________________________________ > > Users mailing list > > [email protected] > > http://list.opensaf.org/maillist/listinfo/users > > > _______________________________________________ > Users mailing list > [email protected] > http://list.opensaf.org/maillist/listinfo/users > _______________________________________________ Users mailing list [email protected] http://list.opensaf.org/maillist/listinfo/users
