The command admreq is to switchover the system controllers.
Try the set command.
Pls refer the following thread for the same.
http://list.opensaf.org/archives/users/2007-September/000254.html
http://list.opensaf.org/archives/users/2007-September/000265.html
- Mathivanan.
________________________________
From: nirmala devi [mailto:[EMAIL PROTECTED]
Sent: Wednesday, December 19, 2007 5:23 PM
To: [email protected]; Mathivanan Np-G19859
Subject: RE: [Users] CLI Problem
My configuration is like this:
2 payloads
1 controller
payload1-/2/3(chasis and slot id ) active
payload2-/2/4(chasis and slot id )standby
now when i run the cli command admreq /2/3 operation locked
command executed successfully but, no impacts on the payload.
(expected behaviour is payload1 should become standby and payload2
should become active)
I hope you got it now??
Rgds,
Nirmala
--- On Wed, 19/12/07, Mathivanan Np-G19859 <[EMAIL PROTECTED]> wrote:
From: Mathivanan Np-G19859 <[EMAIL PROTECTED]>
Subject: RE: [Users] CLI Problem
To: [EMAIL PROTECTED], [email protected]
Date: Wednesday, 19 December, 2007, 5:14 PM
>> payload /2/3 was active and didnot get locked.
>> Any guess what could be wrong?
Could you explain what you meant by "the payload did not get
locked"??
I mean what as your observation?
- Mathi.
________________________________
Save all your chat conversations. Find them online.
<http://in.rd.yahoo.com/tagline_webmessenger_3/*http://in.messenger.yaho
o.com/webmessengerpromo.php>
_______________________________________________
Users mailing list
[email protected]
http://list.opensaf.org/maillist/listinfo/users
