My best advice would be an older LSI/Broadcom HBA which can be found pretty
cheap on eBay these days.

The 9300-8i chip would be a solid starting point.

On Wed, Jan 31, 2024 at 11:05 AM Alessandro Baggi <
[email protected]> wrote:

> Hi,
> This is my feedback about the Silverstone ECS06 SATA controller.
> I'm receiving many problem using the controller. After some days it
> generated many problems:
>
> 1) Slowdown system boot and the system latency is bad.
> 2) There is a bug in the driver about device enumeration. The controller
> has 6 sata port but it enumerates until 36.
> 3) This is a minor problem and fixable. I attached the controller on
> PCI-E 2x and all devices like network adapters are renamed so all
> network configuration was broken and it should be re-done.
> 4) It created some conflicts with my NVIDIA GPU at the point that I
> unplugged the GPU because during every boot it freezed during driver
> loading.
> 5) UEFI problem. I receive on boot a bad message from BIOS/UEFI like this:
>
>   "GPT header corruption has been detected, please check SATA mode
> setting in BIOS Setup, or you can use [Boot Sector (MBR/GPT) Recovery
> Policy] item under [Boot Configuration] page to recovery GPT Headers"
>
> I checked settings in the BIOS and SATA MODE was correct (AHCI). No
> other option configurable for this devices. The only workaround is
> change the recovery policy to Auto. With this config the problem
> disappear but all others not.
>
> I don't know if this is a faulty controller, a driver problem or
> whatever. I tried several configuration and several PCI-E slot but
> nothing helped this controller to work as expected. Removed the
> controller and all problem vanished.
>
> In my case I don't  recommended it.
>
> My 2 cents.
>
> Best regards.
>
> Il 22/01/24 15:09, Alessandro Baggi ha scritto:
> > Hi,
> > Today I installed the ECS06 Silverstone sata controller and it seems to
> > work.
> >
> > Thank you for your advice.
> >
> > Best regards.
> >
> > Alessandro.
> >
> > Il 22/01/24 02:55, Pawel Suchanecki ha scritto:
> >> Hi Alessandro,
> >>
> >> The easiest way to check is by searching for "ASM1166" in the AHCI
> >> kernel driver. You can do this on the GitHub repository for the Linux
> >> kernel:
> >> https://github.com/torvalds/linux/blob/master/drivers/ata/ahci.c
> >> <https://github.com/torvalds/linux/blob/master/drivers/ata/ahci.c>. I
> >> found that the driver does indeed support ASM1166.
> >>
> >> I couldn't locate the exact patch that introduced this change in the
> >> kernel source. However, there's a good chance that it is supported in
> >> the latest releases, as people have been discussing it on the internet.
> >>
> >> Regarding recommendations and stability, I came across a related
> >> thread that might interest you. They mention firmware updates as well:
> >>
> https://forum.openmediavault.org/index.php?thread/46589-unexpected-disk-errors-seen-with-pcie-card-when-adding-more-than-2-disks/
> <
> https://forum.openmediavault.org/index.php?thread/46589-unexpected-disk-errors-seen-with-pcie-card-when-adding-more-than-2-disks/
> >.
> >>
> >> I hope this helps!
> >>
> >> p.s. if you need that, I can double-check our kernel sources tomorrow
> >> for you.
> >>
> >> Pawel
> >>
> >>
> >> --
> >> Pawel Suchanecki
> >> Evangelist / AlmaLinux.org
> >>
> >> The open-source EL: long-term stability trusted by top organizations.
> >>
> >>
> >> On Thu, Jan 18, 2024 at 5:37 PM Alessandro Baggi
> >> <[email protected] <mailto:[email protected]>> wrote:
> >>
> >>     Hi,
> >>     I need to buy a SATA3 PCI-E 3.0 2x controller with 4 or 6 port.
> >>     It will be installed on my workstation. I need to use AlmaLinux or
> at
> >>     least Fedora.
> >>
> >>     Actually I found this:
> >>
> >>
> >> https://www.silverstonetek.com/it/product/info/expansion-cards/ECS06/
> >> <https://www.silverstonetek.com/it/product/info/expansion-cards/ECS06/>
> >>
> >>     but I can't determine if it is supported by the kernel. The
> >> chipset is
> >>     ASMedia ASM1166 (AHCI). I can't find good results on google search.
> >>
> >>     How I can check if the controller is supported?
> >>
> >>     If not what controller do you suggest?
> >>
> >>     Thank you in advance.
> >>     Alessandro.
> >>     _______________________________________________
> >>     AlmaLinux Users mailing list -- [email protected]
> >>     <mailto:[email protected]>
> >>     To unsubscribe send an email to [email protected]
> >>     <mailto:[email protected]>
> >>
> _______________________________________________
> AlmaLinux Users mailing list -- [email protected]
> To unsubscribe send an email to [email protected]
>


-- 
Jonathan Wright
AlmaLinux Foundation
Mattermost: chat <https://chat.almalinux.org/almalinux/messages/@jonathan>

Reply via email to