On 5 January 2015 at 02:06, Simon Langley <[email protected]> wrote: > I want to make Geany use my preferred build commands. I can do it with a > new project by using Build/Set build commands but then have to do it again > for each project. Reading the manual I thought that all I needed to do was > make a copy of the filetypes file and modify it. So, I copied > /usr/share/geany/filetypes.cpp to .config/geany/filedef/filetypes.cpp and > modified [build_settings] and [build_menu] > > [build_settings] > # %f will be replaced by the complete filename > # %e will be replaced by the filename without extension > # (use only one of it at one time) > # compiler=builder compile source=%f > #linker=g++ -Wall -o "%e" "%f" > #run_cmd="./%e" > > [build_menu]
Its build-menu not build_menu Cheers Lex > FT_00_LB=_compile > FT_00_CM=b compile source=%f > FT_00_BD= > > NF_01_LB=_build > NF_01_CM=b build > NF_01_BD= > > NF_02_LB=_clean > NF_02_CM=b clean > NF_02_BD= > > NF_03_LB=_rebuild > NF_03_CM=b rebuild > NF_03_BD= > > I created a new geany project, tried adding/creating .cpp but the build > commands remain at their default settings. What am I doing wrong? > > Thanks, > > Simon Langley > > > > _______________________________________________ > Users mailing list > [email protected] > https://lists.geany.org/cgi-bin/mailman/listinfo/users _______________________________________________ Users mailing list [email protected] https://lists.geany.org/cgi-bin/mailman/listinfo/users
