Hello, first of all I'd like to mention that I am a "newbie", that's why I'd highly appreciate any detailed(transparent) answers concerning the usage of the program(genieacs). We have an ISP network of CPE's(DSL modems); most of the models are: Zhone 1511; Zhone 6511; they are configured manually(upon providing to the Subscribers), with some specific settings so that to meet our network parameters(mostly, for remote management), such as: IP over Ethernet; NAT enabled etc. The need to use the program(genieacs) is mostly, because of the lack of remote management of the CPE's(DSL modems) when they are on their "reset" state; on that state(reset) they are getting an IP address through their "bridge" interface and we no longer can access them remotely; however we are able to gain some info of those devices such as: the MAC address. I hope that with the help of the program(genieacs) we could gain access to those "reset" CPE's through TR069 protocol. Following this: https://github.com/zaidka/genieacs/wiki/Script-Installation---Ubuntu installation guide, I've managed to install and run the program(genieacs) on ubuntu 14.04 LTS. The program seems to run normally(genieacs-cwmp, genieacs-nbi, genieacs-fs and rails.); the gui of the web(http://127.0.0.1:3000) runs normal as well. I am now on a stage of configuration; I was reading the manuals on: https://github.com/zaidka/genieacs/ and following the API reference guide have tried to query to some devices(but with the lack of knowledge to where actually query; I have queried them in a cli session at genieacs installed folder) however so far I was not able to actually "locate" any CPE on our network.. The main question is: how to proceed further after installing the program(genieacs)? I can provide more info, including the screen shots. Would appreciate Your responses; thanks in advance!
_______________________________________________ Users mailing list [email protected] http://lists.genieacs.com/mailman/listinfo/users
