Do you have a way of attaching a console cable to the CPE? I bet it's runnin into a fault condition and rebooting.
-dan > On Jul 4, 2017, at 12:41 AM, Vaggelis Kapoulas <[email protected]> wrote: > > > Hi, > > I face a problem with a Vigor 2860L that reboots after is it connects to a > genieacs server, that I have setup > > The CPE shows in the list of devices, and immediately afterwards a > refreshObject task, that is automatically inserted in the tasks, causes the > CPE to reset. > > This task remains in the list (probably because it got no reply, and is > considered unfinished). > > Once the CPE reboots it sends a new inform (BOOT and VALUE CHANGE, as it now > has a different IP address), the task refreshObject is retried, and this > results again in the CPE rebooting. This goes on and on for ever, if left > uninterrupted. > > If I destroy the queued task(s), then the CPE remains stable, but I cannot do > anything, as any action triggers a new task that causes the CPE to reboot. > > Looking at the debug info I see no obvious cause of the error. The relevant > dump is at https://pastebin.com/fgwciGgx > > I have searched the archives and the web for any relevant clue but have found > nothing so far. > > The CPE was working fine with another TR-069 server (for which I had a test > license that expeired). So I tend to rule out problems with the CPE itself > > I would appreciate any insight into what may be causing this. > > Thanks in advance! > > Best regards, > Vaggelis > > _______________________________________________ > Users mailing list > [email protected] > http://lists.genieacs.com/mailman/listinfo/users _______________________________________________ Users mailing list [email protected] http://lists.genieacs.com/mailman/listinfo/users
