Okay, it looks like I missed that earlier. Is there an issue open on GitHub?
On Fri, Aug 31, 2018 at 2:05 AM Josef Söntgen < [email protected]> wrote: > Hello Ben, > > * Nobody III <[email protected]> [2018-08-30 23:38:47 -0600]: > > > I updated to the 18.08 Genode release, built a Sculpt image, then booted > it > > on my Dell Latitude 6430u laptop. I discovered that the WiFi driver, > which > > worked in 18.05 (Sculpt TC) no longer works properly. In particular, the > > WiFi driver detects the access points and can connect to them, but > doesn't > > get an IP address. I tried multiple access points, both my wireless > router > > and my phone. With my phone, I used a clean lowercase alphabetic SSID > > ("bensphone"), to avoid any issues with problematic characters. I am > using > > an Intel Ultimate-N 6300 wireless card.. Wired networking still works. > > as noted in the release notes, support for 6000er cards has regressed with > the new driver. The cause is still unknown and we are working on a fix. > > (It looks like some kind of race or timing issue as most of the time the > packets submitted to the firmware are not acknowledged but sometimes it > works just fine and the behaviour is influenced by debug messages.) > > Regards, > -- > Josef Söntgen > Genode Labs > > http://www.genode-labs.com/ · http://genode.org/ > _______________________________________________ > Genode users mailing list > [email protected] > https://lists.genode.org/listinfo/users
_______________________________________________ Genode users mailing list [email protected] https://lists.genode.org/listinfo/users
