The config.log looked fine, so I think you have fixed the configure
problem that you previously posted about.
Though the config.log indicates that the BLCR component is scheduled
for compile, ompi_info does not indicate that it is available. I
suspect that the error below is because the CRS could not find any CRS
components to select (though there should have been an error displayed
indicating as such).
I would check your Open MPI installation to make sure that it is the
one that you configured with. Specifically I would check to make sure
that in the installation location there are the following files:
$install_dir/lib/openmpi/mca_crs_blcr.so
$install_dir/lib/openmpi/mca_crs_blcr.la
If that checks out, then I would remove the old installation directory
and try reinstalling fresh.
Let me know how it goes.
-- Josh
On Sep 13, 2009, at 5:49 AM, Marcin Stolarek wrote:
I've tryed another time. Here is what I get when trying to run
using-1.4a1r21964 :
(terminus:~) mstol% mpirun --am ft-enable-cr ./a.out
--------------------------------------------------------------------------
It looks like opal_init failed for some reason; your parallel
process is
likely to abort. There are many reasons that a parallel process can
fail during opal_init; some of which are due to configuration or
environment problems. This failure appears to be an internal failure;
here's some additional information (which may only be relevant to an
Open MPI developer):
opal_cr_init() failed failed
--> Returned value -1 instead of OPAL_SUCCESS
--------------------------------------------------------------------------
[terminus:06120] [[INVALID],INVALID] ORTE_ERROR_LOG: Error in file
runtime/orte_
init.c at line 79
--------------------------------------------------------------------------
It looks like MPI_INIT failed for some reason; your parallel process
is
likely to abort. There are many reasons that a parallel process can
fail during MPI_INIT; some of which are due to configuration or
environment
problems. This failure appears to be an internal failure; here's some
additional information (which may only be relevant to an Open MPI
developer):
ompi_mpi_init: orte_init failed
--> Returned "Error" (-1) instead of "Success" (0)
--------------------------------------------------------------------------
*** An error occurred in MPI_Init
*** before MPI was initialized
*** MPI_ERRORS_ARE_FATAL (your MPI job will now abort)
[terminus:6120] Abort before MPI_INIT completed successfully; not
able to guaran
tee that all other processes were killed!
--------------------------------------------------------------------------
mpirun noticed that the job aborted, but has no info as to the process
that caused that situation.
--------------------------------------------------------------------------
I've included config.log and ompi_info --all output in attacment
LD_LIBRARY_PATH is set correctly.
Any idea?
marcin
2009/9/12 Marcin Stolarek <ms...@icm.edu.pl>
Hi,
I'm trying to compile OpenMPI with checkpoint restart via BLCR.
I'm not sure which path shoul I set as a value of --with-blcr option.
I'm using 1.3.3 release, which version of BLCR should I use?
I've compiled the newest version of BLCR with --prefix=$BLCR, and
I've putten as a option to openmpi configure --with-blcr=$BLCR, but
I recived:
configure:76646: checking if MCA component crs:blcr can compile
configure:76648: result: no
marcin
<info.tar.gz>_______________________________________________
users mailing list
us...@open-mpi.org
http://www.open-mpi.org/mailman/listinfo.cgi/users
