Hi Carlos, I am not sure that I fully understand your question. Have you took a look to the virtual router (VR)?
http://opennebula.org/documentation:rel3.8:router Cheers On Thu, Nov 8, 2012 at 6:21 PM, Carlos Jiménez <[email protected]>wrote: > Hi all, > > I have one computer acting as a frontend running OpenNebula 3.8 and 2 > hosts running KVM. Each hosts has a NIC and a bridge interface on it. If I > configure each VM with an IP on the same network as the hosts, it runs > fine. However, if I configure different networks on each host, I should use > routing on the host. How does OpenNebula deal with hosts clustering when we > have an scenario with routing among the hosts? > We create a VM on each host with an IP of a network A, and another VM on > each host with an IP of a Network B. Then, how does the router identifies > which is the right gateway/host to reach network A and B? > > > Thanks in advance, > > Carlos. > ______________________________**_________________ > Users mailing list > [email protected] > http://lists.opennebula.org/**listinfo.cgi/users-opennebula.**org<http://lists.opennebula.org/listinfo.cgi/users-opennebula.org> > -- Ruben S. Montero, PhD Project co-Lead and Chief Architect OpenNebula - The Open Source Solution for Data Center Virtualization www.OpenNebula.org | [email protected] | @OpenNebula
_______________________________________________ Users mailing list [email protected] http://lists.opennebula.org/listinfo.cgi/users-opennebula.org
