Sorry for resuming the post..
I can't understand how to handle failure messages after parallel forking. I
need a particular configuration or OpenSER must handle them the same way of
a single message?
I'm using OpenSER 1.2.3-tls and also using debug mode I can't see nothing
special.
Thanks.
Regards,
Antonio.
2008/4/15, Antonio Reale <[EMAIL PROTECTED]>:
>
> Hi all,
> I have a Linksys SPA2102 with 2 phones configured with the same
> account/number. If I call that number both phones ring and all is OK.
> The problem is that if I set a call forwarding on one of the two line on
> the SPA only one phone rings.
> Openser receives the 302 message from the SPA but the failure route that
> contains t_check_status("302") is not called.
> The forwarding works if only one line is connected.
> How can I handle the 302 in this situation?
> Thanks in advance.
>
> Regards,
> Antonio.
>
_______________________________________________
Users mailing list
Users@lists.openser.org
http://lists.openser.org/cgi-bin/mailman/listinfo/users
