Hi Anca . As per your suggestions i can add sip buddy from xmpp client. I can even send messages to sip client. But the problem is i cannot reply back to the xmpp buddy. It is getting 403 forbidden error some times and 407 Proxy authentication error some times. I tried to add xmpp buddy in sip client as follows sip:username<delim>jabber_ser...@gateway_domain But in vain. Is any further modifications required in opensips in order to send message to xmpp buddy?. cause that in the error log it is searching for xmpp buddy in usr loc table and it was unable to find that and displaying 403 forbidden error. Can u suggest me where i went wrong.Thanks in Advance!
Anca Vamanu-2 wrote: > > Hi Indiver, > > The 'destination address' refers to the address of the buddy in the > contact list. So in the xmpp account you must add the SIP buddy with the > address: > > "sip_username<delim>opensips_dom...@xmpp_domain" > > xmpp_domain - must be the domain used by opensips when registering as a > component in jabberd2. And the xmpp srv record for that domain must > point to the ip of the machine where jabberd2 is running. > > In SIP, the xmpp buddy must have the following address format: > > "sip:username<delim>jabber_ser...@gateway_domain" > > The gateway_domain is the domain of the opensips gateway. This address > format is used to ensure that the message gets to the gateway. The > gateway will the decode the address and get the right xmpp address of > the target : usern...@jabber_server. > > Regards, > > -- > Anca Vamanu > www.voice-system.ro > > > > Indiver wrote: >> Hi Every one, >> >> I'm working on xmpp module of opensips. I configured opensips as >> component >> mode. I installed jabberd2 and configured successfully. When i look up >> the >> logs of opensips it showing the handshake successful message with my >> local >> jabberd2 server installed in my system. This make foolish but i'm >> confused >> how to move on from here. As i must configure sipcommunicator(jabber >> client) >> with my local jabberd2 server user name and password(i.e u name:jabberd2 >> password:secret)or with the pattern suggested in xmpp doc.Cause that i >> can't understand the format i read in xmpp module of opensips doc.Below >> is >> the part mention in the xmpp doc i confused about, so i'm pasting that >> >> In both cases, the destination address must have the same pattern: >> >> “sip:username<delim>jabber_ser...@gateway_domain” >> >> From a jabber client's point of view, the destination will look like: >> >> “sip_username<delim>opensips_dom...@xmpp_domain” . >> >> what does it mean? . can any one suggest how to move on from here in >> order >> to test configured xmpp module.Thanks in advance >> > > _______________________________________________ > Users mailing list > [email protected] > http://lists.opensips.org/cgi-bin/mailman/listinfo/users > > -- View this message in context: http://n2.nabble.com/xmpp-configuration-tp4192010p4217718.html Sent from the OpenSIPS - Users mailing list archive at Nabble.com. _______________________________________________ Users mailing list [email protected] http://lists.opensips.org/cgi-bin/mailman/listinfo/users
