Of course it did, but the subject was "static routing"....not dynamic :)...
Regards, Bogdan Duane Larson wrote: > > Couldn't the dynamic routing module also be used depending on the > prefixes at each individal remote pbx system? > >> On Oct 22, 2010 12:29 PM, "Bogdan-Andrei Iancu" >> <[email protected] <mailto:[email protected]>> wrote: >> >> Hello Andrea, >> >> If you check the default opensips.cfg, you can see that there is a step >> where only the initial requests are getting there - starting from that >> point you can implement your static routing using "if" statements, >> checking the $rU (request username ) and setting new destination >> (writing in $rd) >> >> Regards, >> Bogdan >> >> >> andrea wrote: >> > Hi, >> > >> > i'm a beginner of OpenSIPS, i've installed 1.6 version using standard >> > con... >> >> Bogdan-Andrei Iancu >> OpenSIPS Bootcamp >> 15 - 19 November 2010, Edison, New Jersey, USA >> www.voice-system.ro <http://www.voice-system.ro> >> >> >> >> _______________________________________________ >> Users mailing list >> [email protected] <mailto:[email protected]> >> http:/... >> > ------------------------------------------------------------------------ > > _______________________________________________ > Users mailing list > [email protected] > http://lists.opensips.org/cgi-bin/mailman/listinfo/users > -- Bogdan-Andrei Iancu OpenSIPS Bootcamp 15 - 19 November 2010, Edison, New Jersey, USA www.voice-system.ro _______________________________________________ Users mailing list [email protected] http://lists.opensips.org/cgi-bin/mailman/listinfo/users
